ENGINEERING SERVICE
1. SOx Scrubber System for ship
2. International Maritime Organization (IMO) has set the maximum allowable content of sulfur in fuel used by ships through MARPOL 73/78 that entered into force in 2005.
3. All ships operating in SECA (Sulfur Emission Control Area) have been required to use fuel with the sulfur content of 1% or less since July 2010 and to use fuel with the sulfur content of 0.1% or less since 2015.
4. Regulatory requirement of using fuels with the sulfur content of 0.5% or less in all oceans throughout the world is to take effect in 2020.
2. International Maritime Organization (IMO) has set the maximum allowable content of sulfur in fuel used by ships through MARPOL 73/78 that entered into force in 2005.
3. All ships operating in SECA (Sulfur Emission Control Area) have been required to use fuel with the sulfur content of 1% or less since July 2010 and to use fuel with the sulfur content of 0.1% or less since 2015.
4. Regulatory requirement of using fuels with the sulfur content of 0.5% or less in all oceans throughout the world is to take effect in 2020.
3D Scan
3D Scan shall be carried out over the whole E/R area including E/R casing.E/R casing outside should be scanned for building the new compartment for scrubber installation.
Basic Engineering includes followings.
1) General 3D Model with structures and major equipment2) Updated arrangement
3) Structure incl. casing and funnel structural enlargement / modification drawings(if necessary)
4) Systems incl. exhaust gas piping scheme / Scrubbing water diagram
5) Electrical and automation incl. single line diagram, electric load balance, short circuit calculation for scrubber panel and new distribution board.
Class approval (1 month)
The approval period is based on that all approval is smoothly passed without delay. If there’s any problem/comments on design especially on structure/strength analysis/Vessel’s stability calculation, the approval period may be delayed and need additional drawing such as lines & offset table etc.Detail Engineering includes followings
1) Material list incl. Cable / Piping / Steel outfitting / Structure etc.2) Pipe /steel outfitting fabrication / Installation drawing
3) Cable/Tray/Coaming installation drawing